CAUTION
Do not pull the bumper more
than 10 mm from its original
position.
3. Carefully pull the bumper towards
the front of the vehicle and
remove the screw.
4. Disconnect the electrical
connector and remove the
headlamp.
CAUTION
When fitting the headlamp, take
care not to damage the locating
points.
Note:
When fitting the headlamp,
make sure that you fully engage the
headlamp in the fixing points.
CHANGING A BULB
WARNINGS
Switch the lights and the ignition
off.
Let the bulb cool down before
removing it.
CAUTIONS
Do not touch the glass of the
bulb.
Only fit bulbs of the correct
specification. See Bulb
specification chart (page 52).
Note:
The following instructions
describe how to remove the bulbs.
Fit replacement in the reverse order
unless otherwise stated.
Headlamp main and dipped
beam
1. Remove the headlamp. See
Removing a headlamp (page
46).
To Next Page
Loading...
Need help?
General
