Setting up the NT8 for initial use means connecting all of the cables, setting up the water and
waste carboys and installing the .NET framework as well as the FTDI drivers to your computer.
A diagram of the setup is shown below for reference.
To set up the NT8 for initial use:
1. Prepare the water and waste carboys. Please note that the water carboy must only be
filled with distilled water. Place the water carboy near the NT8 and the waste carboy
under the table.
Power
Outlet
Computer Laptop
USB Cable
Wash
Tank
Waste
Tank
Power Cable
Setting Up the NT8
To Next Page
Loading...