Formulatrix NT8 - Equipment Safety Guidelines; Mechanical Hazards; Electrical Hazards

4
NT8 User's Guide | Chapter 2: Safety Information
● Read all safety and operating instructions before operating the NT8.
● Do not place the NT8’s facilities connections (power, waste lines and communications
cables) where they could cause a safety hazard.
● Do not place the product in a location where it may be subject to physical damage.
● Ensure that all power connections to the product are properly grounded.
● Do not remove the nameplate, or any warning, hazard, or Equipment Identification
labels.
● Turn OFF power before inserting or removing power cables.
The NT8 is a complex electromechanical device. Only persons with the proper training should
service or operate the product.
All facilities to the product must be disconnected before servicing, or injury may result from the
automatic operation of the equipment.
The proper precautions for operating electrical equipment must be observed.
Equipment Safety Guidelines
Mechanical Hazards
Electrical Hazards
Avoid damage to the power cables. Do not apply unnecessary stress, place heavy objects on,
or crush the cables or fire may occur.
Do not use extension cables unless approved by Formulatrix.
Switch off all power sources before removing connectors or electric shock may occur.
Arrange cables in accordance with the Technical Standard for Electric Properties and Extension
Rules or fire may occur.