NT8 User's Guide | Chapter 6: Initial Setup
Preparing the NT8 for a Dispense
Before running a dispense, you need to prepare the hardware. If you're not familiar with the
components, please see Hardware Overview.
This topic will explain how to station every possible component of the NT8. You may not have
to set up each component for a dispense, so make sure to read the quick start guide before
prepping your hardware to avoid unnecessary hardware setup.
Prerequisites
You are familiar with the NT8 hardware.
This tutorial covers the following topics:
Installing the LV Protein Block
1. Make sure that you have attached the sample
blocks to the protein source.
2. Place the protein source on the protein
source station.
Installing the HV Protein Block
1. Place the HV Protein Tray on Microplate Station 3.
2. Make sure it is secure.
To Next Page
Loading...