P a g e | 33
1. The filter housing is accessed via the right side panel. Thoroughly clean
around filler housing before removing to help prevent debris getting into oil.
2. Unscrew filter housing body, remove filter element and allow to drain for 15
minutes before disposal.
3. Screw on and tighten filter body with new filter into filter housing.
Oils, Fluids and Lubricants.
Engine Oil: HD15w40.
Please consult your supplied Kubota engine operator’s manual for oil quantities
relating to your engine type.
Hydraulic Oil: ISO VG 46.
It is advised that the oil is checked and topped up to the RED LINE on the sight
glass, when the machine is cold and on a flat surface.
Anti-Freeze: Mono-ethylene Glycol at a 59% mix ratio.
Please consult your supplied Kubota engine operator’s manual for coolant quantities
relating to your engine type.
Grease: Lithium EP2 General Purpose. The greasing points can be found on the
control panel. Please do not over grease 2 x pumps per grease nipple per week is
sufficient.
UNSCREW FILTER
BODY TO REPLACE
FILTER ELEMENT
To Next Page
Loading...
