EasyManuals Logo

Fortinet FortiGate FortiGate-100 Administration Guide

Fortinet FortiGate FortiGate-100
388 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
System status Changing unit information
FortiGate-100 Administration Guide 01-28006-0003-20041105 31
To change to NAT/Route mode:
1 Go to System > Status > Status.
2 In the Operation Mode field of the Unit Information section, select Change.
3 In the Operation Mode field, select NAT/Route.
4 Select OK.
The FortiGate unit changes operation mode.
5 To reconnect to the web-based manager, you must connect to the interface
configured by default for management access.
By default in NAT/Route mode, you can connect to the internal interface. The default
internal interface IP address is 192.168.1.99.
Session list
The session list displays information about the communications sessions currently
being processed by the FortiGate unit. You can use the session list to view current
sessions.
Figure 4: Sample session list
Note: If the management IP address was on a different subnet in Transparent mode, you may
have to change the IP address of your computer to the same subnet as the interface configured
for management access.
From IP Set source IP address for list filtering
From Port Set source port for list filtering
To IP Set destination IP address for list filtering
To Port Set destination port for list filtering
Apply Filter Select to filter session list
Virtual Domain Select a virtual domain to list the sessions being processed by that virtual
domain. Select All to view sessions being processed by all virtual domains.
Total Number of
Sessions
Total number of sessions currently being conducted through the FortiGate
unit.
Refresh icon. Select to update the session list
Page up icon. Select to view previous page in the session list
Page down icon. Select to view the next page in the session list.
Protocol The service protocol of the connection, for example, udp, tcp, or icmp.
From IP The source IP address of the connection.
From Port The source port of the connection.
To IP The destination IP address of the connection.

Table of Contents

Other manuals for Fortinet FortiGate FortiGate-100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fortinet FortiGate FortiGate-100 and is the answer not in the manual?

Fortinet FortiGate FortiGate-100 Specifications

General IconGeneral
BrandFortinet
ModelFortiGate FortiGate-100
CategoryFirewall
LanguageEnglish

Related product manuals