System network Interface
FortiGate-800 Administration Guide 01-28006-0008-20041105 53
MTU
To improve network performance, you can change the maximum transmission unit
(MTU) of the packets that the FortiGate unit transmits from any interface. Ideally, this
MTU should be the same as the smallest MTU of all the networks between the
FortiGate unit and the destination of the packets. If the packets that the FortiGate unit
sends are larger, they are broken up or fragmented, which slows down transmission.
Experiment by lowering the MTU to find an MTU size for best network performance.
To change the MTU, select Override default MTU value (1500) and enter the
maximum packet size. For manual and DHCP addressing mode the MTU size can be
from 576 to 1500 bytes. For PPPoE addressing mode the MTU size can be from 576
to 1492 bytes.
Log
Select Log to record logs for any traffic to or from the interface. To record logs you
must also enable traffic log for a logging location and set the logging severity level to
Notification or lower. Go to Log & Report > Log Config to configure logging locations
and types. For information about logging see “Log & Report” on page 351.
HTTPS To allow secure HTTPS connections to the web-based manager through this
interface.
PING If you want this interface to respond to pings. Use this setting to verify your
installation and for testing.
HTTP To allow HTTP connections to the web-based manager through this interface.
HTTP connections are not secure and can be intercepted by a third party.
SSH To allow SSH connections to the CLI through this interface.
SNMP To allow a remote SNMP manager to request SNMP information by connecting to
this interface. See “Configuring SNMP” on page 99.
TELNET To allow Telnet connections to the CLI through this interface. Telnet connections
are not secure and can be intercepted by a third party.
Note: In Transparent mode, if you change the MTU of an interface, you must change the MTU
of all interfaces to match the new MTU.
To Next Page
Loading...
