EasyManuals Logo

Foscam FN7108E-B4-2T User Manual

Foscam FN7108E-B4-2T
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
NVR User Manual
www.foscam.com
4
1.5 Common Operations
Starting Up the NVR
Turn on the power switch on the rear panel. The Power indicator LED should turn green indicating
that the device begins to start up.
Note
If the power LED indicator on the front panel is off, please check if the power supply is plugged into
an electrical outlet and the power switch is turned on;
Shutting Down the NVR
There are two proper ways to shut down the NVR in the GUI interface.
After login, right-click the mouse, you can click Shutdown in the shortcut menu.
Choose Menu > System in the Menu interface, then click Shutdown in the System interface.
Then turn off the power switch on the rear panel, the power LED indicator on the front panel turns
off.
Reset
You can reset the NVR device to restore the factory settings. You can choose any one of the
following methods operate.
Reset button: Press and hold it for 3 seconds to reset all parameters to factory defaults on the
bottom of the NVR.
Local GUI: Choose Menu > System in the Menu interface, then click Factory Reset in the System
interface.
Web GUI: Choose (Parameter Configuration) > System Management > Factory Reset.
The Factory Reset page is displayed.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Foscam FN7108E-B4-2T and is the answer not in the manual?

Foscam FN7108E-B4-2T Specifications

General IconGeneral
BrandFoscam
ModelFN7108E-B4-2T
CategoryCctv systems
LanguageEnglish