NVR User Manual
www.foscam.com
Click this button and back to the realtime preview
window.
There are Local Settings, Settings, Service
Configuration, User Management, System
Management in the Parameter Configuration
interface.
Play back the recorded video files of a specific
channel in the live view mode.
Disconnect the link between the client page of the
current browser and the NVR server.
In channels of the NVR, you can add IPC
devices. The blue indicates that the channel is
previewing state. You can see the video of the
connected camera.
The gray indicates that the channel is o ine state.
There was not the connected camera in this
channel.
Note: If you need to display nine channels IPC
device on the live view window, the sub stream of
each IPC must be less than 720P.
Play an IPC monitoring video in a channel of the
NVR. By default, the video is played.
Stop playing the monitoring video in the channel.
You can configure the preset and cruise of the IP
Camera.
You can configure the LED of the IP Camera.
There are two modes: Manual and Auto.
You can configure the color of the IP Camera.
To Next Page
Loading...
Need help?
General