NVR User Manual
www.foscam.com
Step2 You can configure the following settings.
Format Hard Disk: Click the Format Hard Disk button to initialize the SATA disk for recording.
Note: Initializing the HDD will erase all the data saved on it, please backup the data before
formatting hard disk if necessary.
Disk Saturation:When the disk is saturated, you can choose to stop recording or cycle coverage.
Pre-record Time:The time you set to record before the event.
For example, when an alarm triggered the recording at 11:00, if you set the pre-record time as 5
seconds, the camera records it at 10:59:55.
Step3 Click Save button to take effect.
-------End
System Log
Choose (Parameter Configuration) > Device Information > System Log. The System Log
page is displayed.
The operation, alarm, exception and information of the NVR can be stored in log files, which can be
searched and viewed at any time.
The Log Type contains Alarm log, System log and Operation log.
[Search Log]
1．Select the Channel, Log Type, Date, Start time and End time.
To Next Page
Loading...
Need help?
General