NVR User Manual
www.foscam.com
2.4.1 Channel Config
Channel Config(FN8108H/FN8108HE)
Right-click in live view mode and select Channel Config to enter the Channel Config
interface, On this page you can see device status such as channel, Status, IP Address, MAC
Address, Add IP Camera, Modify IP, Delete/Modify/move up/move down added device.
You can add an IP Camera that is connected to the internet on the NVR.
Step 1: Right-click on main interface, select Channel Config.
Step 2: Select your IP Camera or Auto added IPC.
Step 3: Click Add.
Step 4: Enter username and password of the camera. If your camera is in the factory default state,
you do not need to enter the user name and password.
Step 5: Click OK.
Select a protocol depending on which IP Camera you have.
FOSCAM protocol: The High Definition (HD) IP Cameras for Foscam.
ONVIF protocol: IP Cameras which support ONVIF protocol.
Pair IP Camera(Only FN7108W-B4 kit)
Right-click in live view mode and select Pair IP Camera to enter the Pair IP Camera interface,
On this page you can see device status such as channel, Status, MAC Address, Remove and Add IP
Camera.