Add: Select one preset points and add it to the selected cruise track.
Delete: Select one preset points you have added to one cruise track, click delete.
Move up/ down: Select one cruise track, adjust the order of preset points in one cruise track.
Attention:
Considering the life time and thermal issue of the motor, it’s not recommend to do long-time cruise.
4.8.3 Start-Up Options
Here section will allow you to set the stop position after the camera reboots.
It supports three modes: No self test, Goto home position and Goto preset point.
No self test: When rebooting, the camera will not pan / tilt.
Goto home position: When rebooting, the camera will pa Providing Central Management Software to
manage or monitor multi-cameras n / tilt and stops at center.
Go to Preset point: Select one preset position and save it. When rebooting, the camera will pan/ tilt and
stops at the preset position you have set.
4.9 Firewall
This section explains how to control the access permission by checking the client PC’s IP addresses. It
is composed of the following columns: Block access from these IP addresses and Only allow access
from these IP addresses.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
