Foscam R2 User Manual

66
NOTES:
 Please ensure you have download the correct firmware package for your camera before upgrading.
Read the upgrade documentation (readme.txt file) in the upgrade package before you upgrade.
 Upon downloading the firmware check the sizes of the .bin files. They must match the size in the
readme.txt file. If not, please download the firmware again until the sizes are the same. Your
camera will not function correctly if a corrupt .bin file is used.
 Normally, only Device WEB UI need to be upgrade, please do not try to upgrade the Device System
Firmware.
 Never shut down the power of the camera during upgrade until the IP camera restart and get
connected.
 After upgrade successfully, please uninstall the old plugin and re-install it, then reset the camera to
the default factory settings before using the camera.
4.10.3 Patch Installation
Click "Browse" to select the correct patch file, and then click "Install Patch" to install the patch. Do not
turn off the power during it installing. After installing is complete, you will receive a system prompt.
4.10.4 Factory Reset
Click All reset and all parameters will return to factory settings if selected. This is similar to press the
Reset button on the bottom of the camera.
4.10.5 Reboot
Click Reboot System to reboot the camera. This is similar to unplugging the power to the camera.
Enable Periodic Maintenance:You can choose the reboot period of the camera.

Foscam R2 Specifications

General

Type	IP security camera
PTZ control	Yes
Antenna type	External
Antennas quantity	1
Placement supported	Indoor
Connectivity technology	Wired & Wireless
Form factor	Cube
Mounting type	Desk
Product color	White
Full HD	No
Total megapixels	2 MP
Maximum resolution	1920 x 1080 pixels
Video formats supported	H.264
Minimum illumination	0 lx
Sensor type	CMOS
Optical sensor size	1/3 \
Compatible memory cards	MicroSD (TransFlash)
Maximum memory card size	64 GB
Night vision distance	8 m
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Interface	RJ-45
Power over Ethernet (PoE)	-
Power consumption (typical)	4.8 W
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	20 - 85 %
Harmonized System (HS) code	85258900

Weight and Dimensions

Width	70 mm
Height	120 mm