CT 293 Cyclotec™
3:2 User Manual 6007 0581 / Rev. 3
3.2 Installation
The CT 293 Cyclotec should be positioned on a substantial, non-resonant work
surface with a recommended height of 800-900 mm close to suitable power. Space
requirements are indicated in the
8.2 Technical Data. Install the cord to an electrical
outlet according to Fig. 3:2. Please observe the safety tags on the instrument.
1. Check the voltage and frequency.
2. If the motor is overloaded the overcurrent protection may release. Let cool down
for some minutes. Press the thermal fuse shown in
Fig. 3:2 to reset.
Fig. 3:2
18
US Standard Power Cable,
125V 10A (110-120V Version)
60065342
19 Cyclotec
To Next Page
Loading...
