CT 293 Cyclotec™
User Manual 6007 0581 / Rev. 3 1:3
1.5 Warranty Policy
Warranty conditions are either specified on the order confirmation of the purchase
order together with the invoice, or in the contract with the FOSS representative and
only apply if:
• the Customer/User has followed all written instructions and documentation from
FOSS regarding the product
• the product has been installed, maintained, adjusted and calibrated according to
all descriptions and recommendations in the documentation
• the product has not been used for purposes other than those reasonably
contemplated by FOSS
• the product has not been altered or repaired with non-original FOSS parts or by
personnel not authorised by FOSS
• only original FOSS consumables and accessories or equivalents recommended
by FOSS have been used
• the product has not in any other ways been handled contrary to ordinary practice
• the instrument has been properly maintained, as recommended by FOSS
Your instrument may contain parts that, due to wear during use of the instrument, are
expected to have a shorter lifetime than the instrument in general. These parts are
listed in the User Manual and/or in the FOSS product software and in the Owner's
Guide.
The liability for worn down parts subject to wear is limited to cases with
extraordinary wear due to defective material or production errors.
To Next Page
Loading...
