Foss Cyclotec CT 293 - Operating Instructions; General Information; Operation with Sample Inlet

CT 293 Cyclotec™
User Manual 6007 0581 / Rev. 3 4:1
4 Operating Instructions
Note: Ear Protection is required in the operation of CT 293
Cyclotec
4.1 General Information
The grinding is started with the power switch.
Note: The grinding must also be stopped with the power switch.
The dust pad should also be correctly positioned on the top of sample outlet to
prevent the dust scattering.
4.2 Operation with Sample Inlet.
1. Fasten the sample bottle below the sample outlet.
2. Start the mill with the on/off switch.
3. Introduce the samples into sample bin. The feed rate can be adjusted manually..
Fig. 4:1
4. When the cyclone body is clear of the sample, turn off the mill and then remove
the bottle.
60070581006a