Foundry Hardware Installation Guide for the FES, FESX, and FWSX
2 - 12 © 2006 Foundry Networks, Inc. June 2006
LEDs for FESX and FWSX Ports
The 10/100/1000 Mbps copper and fiber ports, and the 10 Gbps fiber ports on the FESX and FWSX provide status
information using the LEDs listed in Table 2.4.
• The copper ports use square LEDs located in the upper right and left corners of the upper Gigabit copper
connector. The LEDs are combined Lnk/Act LEDs. The LED on the left side is for the upper copper
connector. The LED on the right side is for the lower copper connector.
• The Gigabit fiber connectors use the Lnk and Act LEDs located beneath the mini-GBIC slots for the fiber
ports.
• The 10 Gbps fiber connectors use the LEDs located next to the fiber ports.
LEDs for FESX424-POE Ports
The fiber and copper ports on the FESX424-POE provide status information using the LEDs listed in Table 2.4.
• The 10/100/1000 copper ports (1 – 24) use the LEDs located on the top left and top right of the copper
connectors. The LEDs are combined Link/Activity (Lnk/Act) LEDs. The LED on the left side is for the upper
fiber connector. The LED on the right side is for the lower fiber connector.
• The 10/100/1000 fiber ports (1F – 4F) use the LEDs located beneath the fiber connectors. The LED on the
left side is the Lnk LED, and the LED on the right side is the Act LED.
• The POE ports (1 – 24) use the round LEDs located beneath the copper ports. The first (left-most) LED is for
port 1, the second LED is for port 2, the third LED is for port 3, etc..
To Next Page
Loading...
