Foundry Networks FES - Input Connector; Regulatory Compliance

Foundry Hardware Installation Guide for the FES, FESX, and FWSX
7 - 8 © 2006 Foundry Networks, Inc. June 2006
Input Connector
Table 7.8: Input Connector for Power Supplies
Regulatory Compliance
This section contains regulatory standards for the power supplies, including the following:
• Electromagnetic Compatibility (EMC) compliance
• Immunity regulations
• Safety certifications
• Safety warning labels
• Environmental standards
RPS8-AC
RPSDC-X424-POE
RPS-X424-POE AC
RPS-X448-AC
2.46 in (H) x 8.67 in (W) x 7.6 in (D)
6.25 cm (H) x 22.03 cm (W) x 19.30 cm (D)
6 lbs (2.72 kg)
Power Supply Input Connector Properties
RPS5-AC
RPS8-AC
RPS-X424-AC
RPS-X424-POE AC
RPS-X448-AC
Standard IEC type (IEC320)
C14 type: UL/CSA 15A/250V, VDE 10A/250V
Orientation: Ground pin down
RPS5-DC
RPSDC-X424-POE
RPS-X424-DC
3-position Phoenix Contact
The power supply is connected to Earth Ground using wire attached to the
ground stud on the power supply rear panel.
Table 7.7: Physical Dimensions and Weight of Power Supplies
Power Supply Dimensions Weight