C - 12 © 2008 Foundry Networks, Inc. December 2008
Foundry Hardware Installation Guide for the FES, FESX, and FWSX
WARNING: Disconnect the power cord from all power sources to completely remove power from
the device.
ACHTUNG: Ziehen Sie das Stromkabel aus allen Stromquellen, um sicherzustellen, dass dem
Gerät kein Strom zugeführt wird.
AVERTISSEMENT: Débranchez le cordon d'alimentation de toutes les sources d'alimentation pour couper
complètement l'alimentation du dispositif.
ADVERTENCIA: Para desconectar completamente la corriente del instrumento, desconecte el cordón
de corriente de todas las fuentes de corriente.
WARNING: Make sure that the power source circuits are properly grounded, then use the power
cord supplied with the device to connect it to the power source.
ACHTUNG: Stellen Sie sicher, dass die Stromkreise ordnungsgemäß geerdet sind. Benutzen Sie
dann das mit dem Gerät gelieferte Stromkabel, um es an die Srromquelle
anzuschließen.
AVERTISSEMENT: Vérifiez que les circuits de sources d'alimentation sont bien mis à la terre, puis utilisez
le cordon d'alimentation fourni avec le dispositif pour le connecter à la source
d'alimentation.
ADVERTENCIA: Verifique que circuitos de la fuente de corriente están conectados a tierra
correctamente; luego use el cordón de potencia suministrado con el instrumento para
conectarlo a la fuente de corriente.
WARNING: Do not use the handles on the power supply units to lift or carry a Foundry device.
ACHTUNG: Die Griffe an den Netzteilen dürfen nicht zum Anheben oder Tragen eines
Foundrygeräte verwendet werden.
AVERTISSEMENT: N'utilisez pas les poignées des unités de bloc d'alimentation pour soulever ou porter
un dispositif en châssis.
ADVERTENCIA: No use las asas de las unidades de suministro de corriente para alzar o transportar un
instrumento de Foundry.
WARNING: If the installation requires a different power cord than the one supplied with the device,
make sure you use a power cord displaying the mark of the safety agency that defines
the regulations for power cords in your country. The mark is your assurance that the
power cord can be used safely with the device.
ACHTUNG: Falls für die Installation ein anderes Stromkabel erforderlich ist (wenn das mit dem
Gerät gelieferte Kabel nicht passt), müssen Sie sicherstellen, dass Sie ein Stromkabel
mit dem Siegel einer Sicherheitsbehörde verwenden, die für die Zertifizierung von
Stromkabeln in Ihrem Land zuständig ist. Das Siegel ist Ihre Garantie, dass das
Stromkabel sicher mit Ihrem Gerät verwendet werden kann.