December 2008 © 2008 Foundry Networks, Inc. A - 1
Appendix A
Layer 3 Upgrade Procedures
This appendix describes how to upgrade your device to run the full Layer 3 software code
If you have any questions about performing this upgrade, please contact your place of purchase or Foundry
Networks at 1.877.TURBOCALL (887.2622) inside the United States or 408.207.1600 outside the United States.
You also can send email to support@foundrynet.com.
WARNING: The procedures in this manual are for qualified service personnel.
Upgrade Kit Contents
Before beginning the upgrade, please verify the package contents. If any items are missing from the kit, contact
your place of purchase. The upgrade kit contains the following:
• Electrostatic Discharge (ESD) protection kit
• Upgrade sticker that says “PREMIUM”
• CD-ROM containing the software and documentation
• Upgrade instructions (this document)
• Dual Inline Package (DIP) key (also called a PROM) that has eight pins. You should have one of the part
numbers listed in Table A.1.
To Next Page
Loading...
Need help?
General
