Product Overview
December 2008 © 2008 Foundry Networks, Inc. 2 - 3
multiprotocol routing. All PREM6 models are premium devices that support full Layer 2 switching and full Layer 3
IPv4 and IPv6 multiprotocol routing when shipped from the factory.
For a complete list of software features supported on the FESX and FWSX, see the Foundry FastIron
Configuration Guide. For a complete list of software features supported on FES, see the FES release notes.
POE Applications
Foundry’s FES2402-POE, FES4802-POE, and FESX424-POE provide Power over Ethernet, compliant with the
standards described in the IEEE 802.3af specification for delivering in-line power. The 802.3af specification
defines the standard for delivering power over existing network cabling infrastructure, enabling multicast-enabled
full streaming audio and video applications for converged services, such as, Voice over IP (VoIP), WLAN access
points, IP surveillance cameras, and other IP technology devices.
POE technology eliminates the need for an electrical outlet and dedicated UPS near IP powered devices. With
power sourcing devices, such as Foundry’s FES2402-POE and FES4802-POE, power is consolidated and
centralized in the wiring closets, improving the reliability and resiliency of the network. Because POE can provide
power over Ethernet cable, power is continuous, even in the event of a power failure.
For more information about POE and how to configure it on FES devices, see the Foundry Switch and Router
Installation and Basic Configuration Guide. For information about POE and how to configure it on FESX devices,
see the Foundry FastIron Configuration Guide.
Wireless Applications
You can convert (upgrade) your FastIron Edge Switch to an IronPoint-FES device. Converting your FES to an
IronPoint–FES allows you to run a software image that contains wireless feature support.
To convert your FES to an IronPoint-FES, you need an EEPROM kit, part number FESWLAN. The kit includes a
Dual Inline Package (DIP) key, IronPoint-FES software, upgrade instructions, and other items. Alternatively, you
can order an IronPoint-FES with the EEPROM and wireless software already installed.
You can convert the following FES devices to an IronPoint-FES:
• FastIron Edge Switch 2402
• FastIron Edge Switch 4802
• FastIron Edge Switch 9604
• FastIron Edge Switch 2402–DC
• FastIron Edge Switch 4802–DC
• FastIron Edge Switch 9402–DC
• FastIron Edge Switch 2402-POE
• FastIron Edge Switch 4802-POE
NOTE: You cannot convert the FES12GCF, FastIron Edge Switch X Series, and FastIron Workgroup Switch X
Series to an IronPoint–FES device.
The following IronPoint FES devices ship with the firmware required for the wireless features:
• FastIron Edge Switch 2402-WLAN
• FastIron Edge Switch 4802-WLAN
• FastIron Edge Switch 9604-WLAN
• FastIron Edge Switch 2402-WLAN-DC
• FastIron Edge Switch 4802-WLAN-DC
• FastIron Edge Switch 9604-WLAN-DC
To Next Page
Loading...
Need help?
General
