52
EN
ASSEMBLY OF WORKBENCH’S BACK EXTENSION
1. Use 3 M5 x 16 mm screws, each with a washer and
a stop washer (Z) to fix the extension (F) to the
saw’s workbench.
2. Use 2 M5 x 20 mm screws with the washers to fix
the supporting parts (L) to the saw’s base.
3. Use the two M5 x 20 mm screws with the washers
and the nuts to fix the supporting parts to the back
extension (F).
ASSEMBLY OF THE PUSHER HANGER
To assemble the pusher hanger observe the following pictures.
1 2
3
To Next Page
Loading...
