18
2
18
connected USB devices.
using the connected USB devices. At the same time, a corresponding setting must be set in
BIOS as below:
Set “CMOS Setup” -> “Power Management Setup” -> “USB Wake Up From S3” to “Enabled”.
USBPWR1/2
(Default)
1
2
3
1
2
3
USBPWR1 is for the internal USB connectors, USBPWR2 is for the rear USB ports.
whether under normal condition or in sleep mode.
CAUTION
!
CPU 533 Jumper: CPU_533
MHz, set the jumper to pins 1-2. Return the setting to its
original with pins 2-3 closed.
Enabled
1
2
3
Disabled
(Default)
1
2
3
To Next Page
Loading...
