Foxconn Rattler User Manual

15
2
15
Audio Connector : CD_IN
CD_IN is a Sony standard audio connector, it can
be connected to a CD/DVD-ROM drive through a
CD/DVD audio cable.
Audio Connector : F_AUDIO
The audio connector supports HD Audio standard. It
provides the Front Audio output choice.
USB Connectors : F_USB1/2/3
In addition to the eight USB ports on the rear panel,
this product also provides three 10-pin USB headers
on its motherboard. By connecting through USB cables
with them, user can quickly expand another six USB
ports on the front panel.
Serial ATA Connectors : SATA_1/2/3/4/5/6
The Serial ATA connector is used to connect with
SATA Hard Disk or CD devices which support this
feature. The black connectors support current Se-
rial ATA II interface and allows up to 300MB/s data
transfer rate.The two red connectors support the
current SATA III interface and allows upto 600MB/s
data transfer rate.
IDE Connector : PIDE
With the provided Ultra DMA IDE ribbon cable, you
can connect to any IDE type of hard disk and CD/DVD
ROM/RW drive.
A_MIC2_L
A_MIC2_R
A_LINE2_L
SENSE_SEND
SENSE1_RETURN
PRESENCEJ
EMPTY
SENSE2_RETURN
AUD_GND
1
2
109
F_AUDIO
A_LINE2_R
1 2
109
GND
GND
VCC
D+
D-
D+
GND
D-
VCC
EMPTY
F_USB 1/2/3
Connect a 4-pin
power plug
We recommend you using an 8-pin ATX 12V power supply. If
you are using a 4-pin power supply, you need to align the ATX
power connector according to the picture on the right.
C
A
U
T
I
O
N
!
SATA3_4/SATA5_6
GND
TX+
TX-
GND
RX-
RX+
GND
1
SATA1_2
GND
TX+
TX-
GND
RX-
RX+
GND
1
CD_IN
CD_L GND CD_R
1

Foxconn Rattler Specifications

General

Brand	Foxconn
Model	Rattler
Category	Motherboard
Language	English