Foxwell NT726TS - VCI Manager

25
Next Generation Diagnostic Platform NT726TS User's Manual V1.0
Please make sure your network works correctly and the tablet is fully charged
or connect to external power supply.
Figure 5-2 Sample Update Screen
6 VCI Manager
VCI Manager is used to unbind and bind the built-in VCI. When the built-in
VCI needs to be replaced, you need to use this function to unbind the old VCI
and re-bind the replaced built-in VCI.
Even if the VCI is not replaced, the existing VCI device will be automatically
unbound when unbinding, and then the existing VCI will be automatically
bound, and the software of all vehicles in the device will be rescanned and
refreshed, and finally the APP will be restarted.
NOTE
This function cannot be bound to an external VCI, but can only be bound to a
built-in VCI.
VCI unbind & rebind：
1. Click VCI Manager application on the NT726TS home screen.
2. After clicking Unbind a VCI dongle, it will display whether to unbind the
current VCI. When clicking OK, it will execute unbind, rebind, and refresh the
vehicle.