Franke A600 - Page 25

i
01
4
4
4
4
4
05
02
01
03
02
4
04
03
i
i
Filling and emptying
Page 22
NOTE
If needed, the grind coarseness
can be set in stages for each
grinder.
Set the grind coarseness with
the grinder adjustment wrench.
Information on inserting and
replacing the water fi lter can be
found in the chapter
"Care of the A600", p. 36.
Machine damage
Incorrect fi lling of the machine causes
damage to the machine.
•Fill the water tank with water only.
If there is milk in the Fluid-System.
•Disconnect the machine from the
power supply.
•Call Service.
NOTE
For notes on cleaning the bean
hopper, see Chapter "Care of
the A600", p. 35.
Impairment of function
If the bean hopper and powder container are not locked correctly, this may
impair both the function of the coff ee machine and the product quality.
•Push the locking slide all the way in.
Fill water tank up to marking
with fresh water.
The surface of the sensor must
be dry.
Attach lid.
Slide water tank in.
Pull out the water tank.
Remove the lid.
Filling the water tank (optional)
+2 => very coarse
0 => normal
-2 => very fi ne
Attach the bean hopper.
Push the locking slide up to the stop.
Remove bean hopper upwards.
Empty, clean and dry the bean
hopper.
Pull the locking slide towards
the front up to the stop.
Emptying the bean hopper, setting the grind coarseness