14
Notice: Ensure that the hose is fully inserted and
that there is no gap between the safety valve
and the hose from which water can leak.
4.
below the deck in the cabinet and screw in the
Notice:
clearly above the connection to the drain. This
and not back to the safety group. The distance to
the unit must be < 1 m to use the enclosed
5.
Notice: The drain of the safety valve needs to be
placed after the syphon. If necessary, the
expansion water hose can be shortened with
Ensure that the hose is fully inserted.
Notice: Form a water lock with the expansion
Connect the water supply (“Installation
manual“, page
1.
For UK:
Notice: It is extremely important to install the hat
3.
For UK:
4.
Connect Franke Mythos Water Hub
(“Installation manual“, page 8
1.
Notice: Make sure that the hose is not blocking
any other connection.
3.
Notice: Make sure that the hose is not blocking
any other connection.
4.
Notice: Make sure that the plug is fully inserted.
Notice: Check that there is enough room for all
the components and make sure that the hoses
are not bent, twisted or pulled tight. They should
be routed without kinks. Do not place multiple
socket outlets or portable power supplies at the
rear of the unit.
Filter installation (“Installation manual“,
1. Remove the front cover.
forward and turn the cleaning cup by approx.
Notice:
regular cleaning procedure and shall be kept.
3.
the right until it cannot be tightened any further.
4.
5. Turn on the mains water supply, open the angle
valves and check the installation for seal
integrity. Water must not leak from any point.
Note:
Start-up procedure
During the start-up, Franke Mythos Water Hub
during the process.
To prepare the unit for use, the start-up is
recommended in the following order:
1. Make sure that the tap is correctly aligned above
the sink.
Check the cold and warm water connection with
the manual handle to make sure that the water
supply is working.
3. Plug in the power cord.
Notice: Make sure that the power cord is not
bent, trapped or damaged.
4.
Notice: Do not interrupt the process by pressing
any button or unplugging the device.
5. After the device starts up, the LEDs on the tap
will light up.
EN
To Next Page
Loading...
