CO₂ cylinder operation and replacement
been drawn, the water jet becomes weaker and the
carbon dioxide content lower.
Below 3 bar, the device shows a signal on the
If it is completely empty, no carbonated water can
be drawn from the unit.
The system supports CO
cylinders without
thread. It is compatible with the standard cylinders
available from major marketplaces.
▶
by authorized personnel.
At the end of its life, if for example the sealing is
accordance with the applicable regulations or better
be returned with the local bottle deposit system.
CO₂ cylinder replacement steps
following order (check the details in the “Installation
1. Remove the front cover.
user interface will light up.
3.
reducing valve and enable it to be removed.
Notice:
4.
packaging and check for any damages.
5.
pressure reducing valve by turning it to the right
until it cannot be tightened any further. Tilt the
Notice:
thoroughly tightened so that a tight sealing is
formed. Some gas may escape, and a hissing
noise may be heard. Keep tightening, until it
cannot get any further. No more gas should be
heard escaping.
6.
the user interface will light up as shown on the
left.
7. Install the front cover.
LED color
Warnings for CO
2
cylinder
change
Green
If pressure <3 bar, LED
pulses green;
xL soda can still be obtained
Removal of the product
We recommend removing the product in the
following order (check the details in the “Installation
1. Make sure that the tap is correctly aligned above
the sink.
Unplug the power cord.
3.
angle valves.
4. Remove the front cover.
5.
reducing valve and enable it to be removed.
6. Install the front cover.
7.
Warning: Danger of scalding! The safety valve
never be disconnected from the unit!
8.
The unit with the connected safety valve can
now be safely removed from the cabinet.
Notice: The Franke Mythos Water Hub must
always be transported in appropriate packaging.
EN
To Next Page
Loading...
