Filter operation and replacement
A reliable system function can only be achieved if
change cycles depend on the application and
associated water consumption.
hazard free in domestic waste.
Filter replacement steps
following order (check the details in the “Installation
1. Make sure that the tap is correctly aligned above
the sink.
Remove the front cover.
3.
the user interface will light up.
4.
and enable it to be removed.
Notice: During this process, incoming tap water
that a small amount of expansion water leaks
Please keep this in mind and place a suitable
5.
the right until it cannot be tightened any further.
6.
continuous to light up red.
7. The light on the electronic knob will be orange;
press the electronic knob for starting the
Notice:
8. Install the front cover.
Filter setting for water hardness
▶
▶ Turn backwards for corresponding water
hardness setting.
▶
Water hardness LED color Filter lifetime
light blue
yellow
light green 8 months
purple 6 months
* default setting
LED color Warnings for lter change
Orange
LED lights up orange
runtime LED orange
pulsating
Red/Orange
detected
EN
To Next Page
Loading...
