11
8.6: Audio input and headphone jack output;
If you insert your headphones into headphone jack, the audio from USB, SD, or radio it will
transfer to the headphones.
You can connect external audio equipment to Audio input jack, to play select AUX
Notice: While the iPhone/iPad dock is in use the plugged in device will charge, Music selection must
be made on the device itself. If there is a cable plugged in to the audio input jack it will override the
docking cable.
9.0 Fan: You can press “FAN” button to start the on-board fan.
QUICK START GUIDE (Manual mode)
1. Turn power switch on; attach the magnet of the safety key to the console 0.00 will be displayed on the
screen, this state is further referred to as standby.
2. Press START button the unit will count down from 3 the buzzer will make sound the count will be shown in
the speed window once 0 is reached the treadmill will start at 1.0km/hour.
3. After start-up, you can use “SPEED+” or “SPEED-” to adjust the speed up or down, and use “INCLINE^” or
“INCLINEv” to adjust the incline up or down.
4. Press stop to complete workout.
MANUAL TARGET MODE: (Target TIME, DISTANCE or CALORIES)
1. While in standby press the “PROG” button the dot matrix display will show a T and the default time in the
TIME window will now be 15:00; pressing “SPEED+”, “SPEED-”, “INCLINE^” or “INCLINEv” will change the
target time. Adjust the target to the desired time; press START button to start the work out. The time will count
down from the set point to 0:00. Once 0:00 is reached the treadmill will slow down, stop and it will finish in
standby mode.
2. While in standby twice press the “PROG” button the dot matrix display will show a D and the default time in
the DISTANCE window will now be 1.0; pressing “SPEED+”, “SPEED-”, “INCLINE^” or “INCLINEv” will
change the target distance. Adjust the target to the desired distance; press START button to start the work out.
The distance will count down from the set point to 0.00. Once 0.00 is reached the treadmill will slow down,
stop and it will finish in standby mode.
3. While in standby press the “PROG” button 3 times the dot matrix display will show a C and the default time
in the CALORIE window will now be 50; pressing “SPEED+”, “SPEED-”, “INCLINE^” or “INCLINEv” will
change the Calorie target. Adjust the target to the desired amount of Calories; press START button to start the
work out. The distance will count down from the set point to 0. Once 0 is reached the treadmill will slow down,
stop and it will finish in standby mode.
To Next Page
Loading...
