19
CLEANING
WARNING: ALWAYS UNPLUG THE TREADMILL FROM THE ELECTRICAL OUTLET BEFORE CLEANING OR
SERVICING THE UNIT.
General cleaning or the unit will greatly prolong the life of the treadmill. Keep treadmill clean by dusting
regularly. Be sure to clean the exposed part of the deck on either side of the walking belt and also the side rails.
This reduces the build-up of foreign material underneath the walking belt.
The top of the belt may be cleaned with a damp, soapy cloth. Be careful to keep liquid away from inside the
motorized treadmill frame or from underneath the belt. Warning：Always ensure the treadmill is unplugged
from the electrical outlet before removing the motor cover. At least once a year remove the motor cover
and vacuum under the motor cover.
WALKING BELT AND DECK LUBRICATION
The treadmill is equipped with lubricated running board, which needs regular maintenance. The friction between
running board and running belt has a great effect on the treadmills’ life.
The steps are as follows:
a) Remove the power cord from the wall socket.
b) Wipe out the dust between running board and running belt with a clean cloth.
c) As shown in the picture apply the Silicon oil on the running board (2 small daubs about 50mm in diameter
approximately where your feet hit the deck during use).
d) Plug the treadmill back and set running to the lowest speed. Slowly walk the silicon over the surface of the
treadmill deck.
To Next Page
Loading...
