Fritz! 6000 - Disabling Adoption of Settings from the Mesh

Disabling Adoption of Settings from the Mesh
Overview
In the Mesh of a FRITZ!Box, the FRITZ!Repeater automatically adopts
certain settings from the FRITZ!Box (Mesh Master) by default; see
page36.
You can disable the adoption of settings in the Mesh and configure cus-
tomized settings for your FRITZ!Repeater. Doing so does not remove
the FRITZ!Repeater from the Mesh.
Requirements
• The FRITZ!Repeater is in the Mesh of a FRITZ!Box
Rules
Disabling adoption of the settings results in the following restrictions:
• Changes to settings in the FRITZ!Box are no longer automatically
adopted by the FRITZ!Repeater.
• Mesh steering is no longer available for the FRITZ!Repeater.
Instructions: Disabling Adoption of the Settings from the Mesh
1. Open the user interface; see page44.
2. Select “Access to Home Network”.
3. Disable the option “Adopt settings enabled” in the “Adopt
Settings from the Mesh” section.
4. Click on “Apply” and wait until you receive the message that the
FRITZ!Repeater configuration has been concluded.
FRITZ!Repeater 6000 52
User Interface: Access to Home Network Menu
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •