Installing the Current Service Pack
111
2. Open the user interface in a web browser. Proceed as
described in the section “Opening the User Inter-
face” on page 28.
3. Go to the “WLAN / Security” menu and select “non-
enctypted”. As a final step, click “Apply”.
4. Remove the network cable and try again to establish
a connection.
If the attempt to connect to the WLAN using the non-en-
crypted connection is not successful either, check the in-
stallation of the WLAN adapter and contact the manufac-
turer of the WLAN adapter if necessary.
Enable WLAN encryption again after completing the tests.
Follow the steps listed above and then enable the kind of
encryption that was previously configured.
Installing the Current Service Pack
The WLAN connection to the FRITZ!Box cannot be
established using the Microsoft WLAN Service (WZC) in
Windows XP with Service Pack 2.
The required Microsoft patch for WPA2 (IEEE 802.11i) may
not be not installed.
Install Service Pack 3 (SP3) for Windows XP, available as a
free download from Microsoft. Then Microsoft WLAN Ser-
vice will support WPA2, so that a WLAN connection can be
established to the FRITZ!Box.
This non-secured condition should be used only for
testing, to find out whether a WLAN connection is
possible at all.
Possible Cause
Remedy
To Next Page
Loading...
Need help?
General
