16
Note: The outdoor rated adapter and extended power cable can be
purchased separately:
Figure 6: Sensor package mounting diagram
5.2.3 Reset Button and Transmitter LED
In the event the sensor package is not transmitting, reset the sensor.
Using a bent-open paperclip, press and hold the RESET BUTTON to affect a
reset: the LED turns on while the RESET button is depressed, and you can
now let go. The LED should then resume as normal, flashing approximately
once every 8.8 seconds.
5.2.4. Calibration
The ultrasonic sensor has been calibration before leaving the factory. We do
not recommend that customers do calibration by themselves.
Customers use this feature only when the wind speed does not return to zero
when there is no wind
Accessory Part only, not included!
To Next Page
Loading...
