Original manual – Iss. 0.1 User manual – BM 3E Freezer 14/ 44
6. GENERAL USE
6.1 Commissioning
Follow the instructions in the correct order:
1) Install the drawers or shelves in each level.
2) Connect the freezer to a power outlet (230 V 50 Hz 16 A + neutral + earth) protected by a 30 mA differential circuit
breaker (the compressor(s) and fan will start up).
Press the On/Off button.
3) The screen displays “Froilabo” (start-up phase), then shows the temperature inside the chamber.
4) Adjust the setpoint (-45°C or -80°C by default, depending on model).
See the procedure in section 6.4 Adjusting the temperature setpoint.
5) Wait until the freezer reaches the set temperature (3 to 6 hours depending on model).
6) Load the freezer.
Note 1: The temperature in the freezer may rise if it is loaded with “hot” products. The high temperature alarm may
be triggered.
Note 2: The switch cuts off only the internal 24 V power supply required in particular for the processor and display.
The freezer is still powered as long as the power cable is connected to the mains.
Any electrical maintenance must be performed by qualified staff.
To Next Page
Loading...
