10
P331 M_HA mane-12.fm
6OPERATION
6.1 Installation
Do not expose power tools to rain or wet conditions!
The batteries are supplied partially charged.
Before the first use, the battery must be completely charged.
See separate operating instruction of the battery charger.
Never charge a damaged battery. Replace by a new one immediately.
Do not open batteries and store them only in dry and frost-proof rooms.
Do not store the battery pack together with metal objects (short circuit risk).
The maximum ambient temperature is 50°C.
Keep dry at all times.
Inserting the battery
• Insert the battery from top to bottom into the tool until the
unlatching push button is engaged.
When inserting the battery the LED - indication shortly lights
green.
Removing the empty battery
If the red LED starts lighting while a tensioning or welding
procedure, the capacity of the battery is exhausted. All
electric functions of the tool are blocked.
The battery must be recharged.
• Push the unlatching push button at the battery.
• Pull the battery out of the tool.
Displaying of the status of the battery charge
By pressing a button the status of the battery can be
shown in four steps.
If four lamps are lighting the battery is full.
If only one lamp is lighting shortly the battery has to be
charged.
To Next Page
Loading...
