EasyManua.ls Logo

Fronius Acctiva Professional Flash - Troubleshooting; Service Codes

Fronius Acctiva Professional Flash
88 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
50
Troubleshooting
Service codes
Troubleshooting
112 Open circuit voltage detection faulty
Remedy: Replace power module PC board
202 Timeout in the first charging phase
Remedy:
- Set correct battery capacity (Ah)
- Check for parallel consumers (car radio, etc.)
203 Charge time exceeded
Remedy: Check battery
205 Cell short circuit
Remedy: Check battery
302 Temperature sensor defective
Remedy: Replace power module PC board
Polarity reversal of charging terminals
Cause Charging terminals connected to wrong poles
Remedy Swap charging terminals round
Charging terminals short-circuited
Cause Short-circuit on the charging terminals
Remedy Rectify short-circuit on the charging terminals
Cause Battery not detected
Remedy Check that charging terminals are properly connected, press
Start/Stop button for 5 seconds
Overtemperature
Cause Overtemperature - battery charging system too hot
Remedy Allow battery charging system to cool down
Cause Air inlets and outlets covered
Remedy Ensure air inlets and outlets are not obstructed

Table of Contents

Other manuals for Fronius Acctiva Professional Flash

Related product manuals