67
EN
Feed and plug in cable (5) and (6)
Make sure all cables are securely connected
Fit the housing (see "Fitting the housing")
Replacing the di-
ode
Removing the diode:
Remove power module PC board (see "Replacing power module PC board")
Undo the two TX20 screws and remo-
ve the diode
Clean the surface under the diode
Installing the diode:
Apply heat conductive paste to the new
diode using a syringe
Spread the heat conductive paste
evenly and thinly across the entire sur-
face with the roller
Fit the diode into the device using the two TX 20 screws - 2 Nm. The screw recess (1)
must point towards the DC connection side of the battery charging system
Install power module PC board (see "Replacing power module PC board")
9
10
11
1
TX 20
2
3
(1)
1
2
3
4
To Next Page
Loading...
