To Next PageTo Next PageWhat to do if my Fronius Battery Charger shows over-temperature?
If the Fronius Battery Charger is too hot due to over-temperature, allow it to cool down. Also, make sure that the air inlets and outlets are not obstructed.
Why is there nothing on the display of my Fronius Battery Charger?
If there is nothing on the display of your Fronius Battery Charger, first, ensure the mains supply is connected. If it is, the mains plug or mains cable may be faulty, and you should replace it. If the problem persists, the charger itself may be faulty.
Why does the Fronius Acctiva Professional Flash show a safety cut-out?
If the Fronius Battery Charger safety cut-out is activated, check the battery for faults. Also, verify the charger settings for Ah and voltage, and ensure the correct battery type and number of cells (voltage) are selected.
How to fix a Fronius Battery Charger that does not start charging?
If the Fronius Battery Charger does not start charging, the charging terminals or charger lead may be faulty. Replace the charging terminals or charger lead, ensuring the M8 nut torque is 15 Nm.
What to do if Fronius Acctiva Professional Flash is not detecting the battery?
If the Fronius Battery Charger is not detecting the battery, check that the charging terminals are properly connected, and press the Start/Stop button for 5 seconds.
How to fix Fronius Acctiva Professional Flash Battery Charger charging terminals connected to wrong poles?
To resolve charging terminals connected to the wrong poles, swap the charging terminals around.
What to do if Fronius Acctiva Professional Flash Battery Charger charging terminals are short-circuited?
If the charging terminals of your Fronius Battery Charger are short-circuited, rectify the short-circuit on the charging terminals.
General| Output Voltage | 12 V / 24 V |
|---|---|
| Charging Current | 70 A |
| Mains Voltage | 230 V |
| Input Frequency | 50/60 Hz |
| Protection Class | IP20 |
