7
Charging the battery
CAUTION! Risk of damage when attempting to charge a faulty battery. Before
charging, ensure that the battery to be charged is fully functional.
Starting charging
4. Connect (+) charging terminal to positive pole on battery
5. Connect (-) charging terminal to negative pole on the battery, or to vehicle body (e.g.
engine block) in the case of vehicle electrical systems.
6. Charger detects that the battery is connected and starts charging
2. Select battery type and corresponding operating mode
3. Set the capacity of the battery to be loaded.
1.
CAUTION! Danger of damage to the in-car electronics by refresh charging.
Before beginning refresh charging, disconnect battery from vehicle power
supply.
1. Once the charging terminals are connected, press start/stop button for approx. 5
secs
WARNING! Risk of serious damage as a result of incorrectly connected char-
ging terminals. The reversal polarity protection facility is inoperative if charging
is started manually (battery voltage < 1.0 V). Connect charging terminals to
correct poles and ensure proper electrical connection to vehicle terminals.
Starting charging
manually (deep-
discharge batte-
ry)
Important! If the battery voltage is < 1.0 V, the battery will not be automatically detected.
Charging must be started manually:
„Wet“ mode
„Refresh wet“ mode
„GEL“ mode „Refresh GEL“ mode
To Next Page
Loading...
