Fronius Acctiva Professional Flash - DEVICE VERSION Submenu (Hardware and Firmware Version); DELAY TIME Submenu (Delay Time)

17
DELAY TIME
submenu
(delay time)
DEVICE VERSI-
ON submenu
(hardware and
firmware version)
1. Access the submenu
2. Set delay time. Setting range: 0 - 4 h (can be set in increments of 10 min)
1. Access the submenu
3. Exit the submenu
3. Save the selected time and exit the submenu
2. Toggle between hardware version and firmware version displays by pressing the info
button.
Important! Delay time must be set again after each cycle. If the power fails, the count-
down stops. Once the power is restored, the countdown continues where it left off.