11
Stopping the
external power
supply
CAUTION! Risk of sparks when disconnecting the charging terminals. Before
disconnecting the charging terminals, stop external power supply by pressing
the Start/Stop button.
Boost mode If the battery voltage drops while power is being supplied externally because more power
is needed (e.g. because additional consumer loads are switched on), the device goes
into boost mode.
Important! To keep the battery voltage at a constant level, the charger can increase the
current to the set external supply current. In prolonged periods of high current demand,
the charger will automatically decrease the current once the maximum operating tempe-
rature is reached.
1. Stop the external power supply
2. Disconnect (-) charging terminal from the negative pole of the system being sup-
plied, or from the vehicle body (e.g. engine block) in the case of vehicle electrical
systems
3. Disconnect (+) charging terminal from the plus cable of the system being supplied
4.
To Next Page
Loading...
