Fronius Acctiva Professional Flash - PRESET Submenu (Preferred Settings)

15
PRESET subme-
nu (preferred
settings)
Important! To avoid damage to the in-car electronics, the following modes cannot be
saved:
- „Refresh wet“
- „Refresh GEL“
1. Access the submenu
Preferred Setting used mode (factory setting):
After disconnecting the charging terminals or mains supply, the last mode se-
lected is saved.
Preferred Setting FSV: Save „external power supply“ mode
After disconnecting the charging terminals or mains supply, the external power
supply mode is saved.
Preferred Setting wet: Save „wet“ mode.
After disconnecting the charging terminals or mains supply, the „wet“ mode is
saved.
Preferred Setting GEL: Save „gel“ mode:
After disconnecting the charging terminals or mains supply, the „gel“ mode is
saved.
2. From the submenu, select:
3. Save the desired mode and exit the submenu.
Important! Regardless of the „preferred setting“ saved, another mode can be selected
at any time. After disconnecting the charging terminals or mains supply, the device
automatically reverts to the saved „preferred setting“.
PRESET subme-
nu (preferred
settings)
(continued)
NOTE! Power failure can influence the charging performance. After a power
failure, check that the desired mode is still set. Correct the mode as required
and restart charging.