Fronius Acctiva Professional Flash - USER U;I Submenu (User Settings for Current and Voltage)

13
USER U/I subme-
nu (user settings
for current and
voltage)
2. Enter password 3831:
- Using the arrow keys, enter the correct digit in the underlined position
- Press the info button to go to the next position
- Repeat the process until all four digits have been entered correctly
- Press the Start/Stop button to confirm the password is correct
3. Set „wet“ end-of-charging voltage (setting range: 12.0 - 15.5 V)
- Press Start/Stop button
- Display flashes. Adjust end-of-charging voltage in 0.1 V steps
- Press Start/Stop button to confirm setting
5. Set maximum charging current (Setting range: see Technical Data)
- Press Start/Stop button
- Display flashes. Adjust max. charging current in 0.5 A steps
- Press Start/Stop button to confirm setting
1. Access the submenu
4. Set „gel“ end-of-charging voltage (setting range: 12.0 - 15.5 V)
- Press Start/Stop button
- Display flashes. Adjust end-of-charging voltage in 0.1 V steps
- Press Start/Stop button to confirm setting