Up/Down func-
tion
The Up/Down torch has the following func-
tions:
- Changes the welding power in Syner-
gic operation via the Up/Down buttons
- Error display:
• all the LEDs light up red if there is
a system fault
• all the LEDs flash red if there is a
data communication fault
- Self-test during the run-up sequence:
• all LEDs light up briefly one after
the other
JobMaster func-
tion
The JobMaster welding torch has the fol-
lowing functions:
- The desired welding parameter on the
power source can be selected using
the arrow buttons
- The parameter can be changed using
the +/- buttons
- The display shows the current para-
meter and value
Proper use The MIG/MAG manual welding torch is intended solely for MIG/MAG welding in manual
applications.
Any use above and beyond this purpose is deemed improper. The manufacturer shall not
be held liable for any damage arising from such usage.
Proper use includes:
- Carefully reading and following all the instructions given in the operating instructions
- Performing all stipulated inspection and maintenance work.
43
EN
To Next Page
Loading...
