7 8
**** Screw the cap onto the inner liner as far as it will go. The inner liner must be visi-
ble through the hole in the cap.
9
NOTE!
Steel inner liners with an outer diame-
ter of less than 1 mm (0.039 in.) cannot
be screwed into the welding torch - the
specified tightening torque therefore
does not apply to these liners.
All other inner liners must be screwed into
the welding torch and tightened to the spe-
cified tightening torque.
10
Attaching the
torch body
CAUTION!
Risk of damage to the welding torch.
▶
Always tighten the union nut on the torch body as far as it will go.
52
To Next Page
Loading...
