Fronius Robacta PTW 3500 - Assembling the Robacta PTW 500, 1500, 3500; Assembling the Robacta PTW 500

6
3
1
2
3
Assembling the Robacta PTW 500, 1500, 3500
Safety
Assembling the
Robacta PTW 500
WARNING! Work that is carried out incorrectly can cause serious injury and
damage. The following activities must only be carried out by trained and quali-
fied personnel. Follow the safety regulations.
Insert clamping sleeve
Assemble centring tube, plasma nozzle and
shielding gas nozzle
Insert tungsten electrode
Important! Insert the tungsten electrode so that the tip protrudes approx. 10 mm out of
the torch body. Slightly tighten the torch cap so that the tungsten electrode can still move
inside the torch body.
1
1
2
3
4
5
2
2
2x360°
3
1
Important! Check that the tungsten
electrode is adjusted correctly (see „Ad-
justing the tungsten electrode“)