Fronius Robacta PTW 3500 - Assembling the Robacta PTW 1500; Assembling the Robacta PTW 3500

7
EN
Assembling the
Robacta PTW
1500
Fit holder, insert clamping sleeve
Assemble centring tube, plasma nozzle and
shielding gas nozzle
Insert tungsten electrode
4
1
2
3
1
2
2
1
3
Important! Insert the tungsten electrode so that the tip protrudes approx. 10 mm out of
the torch body. Slightly tighten the torch cap so that the tungsten electrode can still move
inside the torch body.
∼
10 mm
Assembling the
Robacta PTW
3500
Fit holder, insert clamping sleeve
Insert tungsten electrode
1
1
3
4
2
2
1
2
Important! Check that the tungsten
electrode is adjusted correctly (see „Ad-
justing the tungsten electrode“)
max. 3 Nm