Fronius Selectiva 2040 2kW - Reset Settings; USB Mode

45
EN
Reset settings The menu item below "General options" offers two alternative ways of resetting all the set-
tings:
Reset Factory Settings:
- Resets to factory settings
Reset Default Settings:
- Resets settings to the manufacturer's
defaults
USB mode
In USB mode, the display shows whether or
not a USB flash drive is connected.
The USB flash drive must conform to the
following specifications:
- Formatting: FAT32
- 32 Gigabyte maximum
- Non multi-partitioned
The I-SPoT VIEWER software supports the visualisation and evaluation of data on the
USB flash drive.
Only insert the USB flash drive when charging is not in progress of if the charging process
has been interrupted.
If the charging process is only interrupted, not completed, it is only possible to read out da-
ta. A new update or configuration cannot be loaded.
- Safely remove
Safely remove the USB flash drive as soon as the desired action has been completed.
Use the "Stop/Start" key to access the following settings.
Use the "Up/Down" keys to scroll between the settings.
Use the "Stop/Start" key to confirm the desired setting.
1
2
3