5
Manual electrode welding
1. Plug the welding cable into current socket (A) or (B) , depending on the type of
electrode, and turn it clockwise to latch it
2. Plug the machine into the mains
3. Shift the mains switch (1) into the "I" position
Manual electrode
welding
Warning! An electric shock can be fatal. As soon as you shift the mains switch
(1) into the "I" position, the rod electrode becomes live. Make sure that when
this happens, the rod electrode does not touch any electrically conducting or
earthed parts such as e.g. the workpiece, machine housing etc.
4. Operational readiness indicator (2) is lit up
5. Select the arc force on the arc-force dial (5)
6. Select the desired amperage on the welding current dial (3)
7. Start welding
Important! If the TP 2000 R.C. welding machine is used with a remote-control unit, then
it is only possible to adjust the welding current on this r.c. unit. The maximum welding
current that can be selected is indicated by the welding dial on the machine (3) .
To Next Page
Loading...
